Load data for .260 PICRA + .264 | 139gr | Brenneke TOG

Recommended Powder(s): Accurate No. 11 FS, ReloadSwiss RS 30, Somchem S265

Load Specifications

(Use the Personalized Load Calculator below to adjust )

Bullet:	.264 \| 139gr \| Brenneke TOG
Bullet Weight:	139gr \| 9.0g
Bullet Diameter:	0.264" \| 6.71mm
Bullet Length:	1.284" \| 32.6mm
Caliber:	.260 PICRA load data
Case Length (l3):	1.515" \| 38.5mm
Cartridge Length (C.O.L.):	2.404" \| 61.1mm
Seated Depth:	0.395" \| 10.0mm
Shank Seated Depth:	0.338" \| 8.6mm
Case Capacity:	38.6 Grains of Water \| 2.51 cm³
Primer Size:	Large Pistol (LP)
Max. allowed Pressure:	56565 psi \| 3900 bar
LID:	LID_B1159_C251
Last updated:	2025-01-01

Load data for 46 loads in caliber .260 PICRA with .264 | 139gr | Brenneke TOG bullet and 23 powders such as Accurate No. 11 FS, ReloadSwiss RS 30, Somchem S265. The key underlying parameters are shown in the table above.

Important Notice: DO NOT go below Minimum Charge or above Maximum Charge unless there are reasons. Since xxlreloading.com has no control over the equipment and components used by the customer and the data used in connection with the website, any responsibility and liability for the results achieved is rejected. Also see our Terms of Service.

Questions regarding the load data: Please read the information in the next tab "Explanations".
A load must fulfill certain criteria to be listed in the default view below - see "powder criteria to fulfill to be listed".

Our load data might deviate from other sources - see the "most common reasons for deviations".

All loads are based on the bullet and case dimensions shown under "Load Specifications" - see "reloading suggestions" if you deviate.

You can set your specifications in the "Personalized Load Calculator".

Go to the bottom of the "Dashboard " page to set the measure system (imperial vs. metric)
No data yet
C.O.L. (Inch)
C.O.L. (mm)
We recommend you limit powder range to relevant brands to speed up re-calculation of results
Use the Personalized Load Calculator to customize loads to your own specific requirements. Find more details in the help section.

Our default view only displays powders/loads that fulfill certain criteria: Max pressure of a load <=90% of Max. Standardized Pressure. Fill Rate (Min FR): >80% and <100% for rife loads, >60% and <100% for pistol loads. Min. Propellant Combustion (Min z): >90% for rifle loads , >80% for pistol/revolver loads. Relax these criteria at your own risk to potentially get more powders shown in the load tables.
Case Length (Inch)
Case Length (mm)
CaseCapacity (GoW)
Min z (%)
Min FR (%)
Max FR*
Barrel Length (Inch)
Barrel Length (cm)
Safety Buffer (%)
.

Click on the desired row in the tables below to add a specific load / powder to your Diary and manage there.

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	66%	49806	88%	**91	100%
ADI APS 350	<<locked>>	73%	50067	89%	**34	100%
ADI APS 450	<<locked>>	72%	49240	87%	**43	100%
ADI AS 30	<<locked>>	69%	50473	89%	**66	100%
Accurate No. 11 FS 👍	<<locked>>	67%	50807	90%	**49	99%
Accurate Solo 1000	<<locked>>	65%	49487	87%	**73	100%
Accurate Solo 1250	<<locked>>	63%	49690	88%	**89	100%
Alliant BLUE DOT	<<locked>>	64%	50604	89%	**70	100%
Baschieri & Pellagri 100	<<locked>>	63%	49734	88%	**60	100%
Hodgdon Clays	<<locked>>	71%	49748	88%	**47	100%
Hodgdon TrailBoss	<<locked>>	97%	32895	58%	**43	100%
Maxam CSB 1	<<locked>>	66%	50096	89%	**96	100%
Maxam CSB 3	<<locked>>	64%	49777	88%	**76	100%
Maxam CSB 4	<<locked>>	65%	50618	89%	**83	100%
Maxam CSB 5	<<locked>>	64%	49995	88%	**63	100%
ReloadSwiss RS 14	<<locked>>	95%	32242	57%	**53	100%
ReloadSwiss RS 30 👍	<<locked>>	75%	50502	89%	**35	100%
SNPE Vectan A0	<<locked>>	64%	50676	90%	**19	100%
SNPE Vectan BA10	<<locked>>	68%	50009	88%	**47	100%
SNPE Vectan BA6 1/2	<<locked>>	79%	50415	89%	**86	100%
Somchem S265 👍	<<locked>>	72%	50372	89%	**26	100%
Vihtavuori N110	<<locked>>	70%	50169	89%	**99	100%
Vihtavuori N32C Tin Star	<<locked>>	87%	50459	89%	**34	100%

Max Load - Barrel Length: 5.50''

Powder	Charge	FR	MaxP	%	V(0)	z
ADI AP 100	<<locked>>	61%	42931	76%	**25	100%
ADI APS 350	<<locked>>	61%	39436	70%	**22	100%
ADI APS 450	<<locked>>	61%	39262	69%	**29	100%
ADI AS 30	<<locked>>	61%	43236	76%	**91	100%
Accurate No. 11 FS	<<locked>>	61%	41727	74%	**11	97%
Accurate Solo 1000	<<locked>>	61%	45803	81%	**34	100%
Accurate Solo 1250	<<locked>>	61%	47761	84%	**66	100%
Alliant BLUE DOT	<<locked>>	61%	47210	83%	**37	100%
Baschieri & Pellagri 100	<<locked>>	61%	47834	85%	**37	100%
Hodgdon Clays	<<locked>>	61%	40625	72%	**35	100%
Hodgdon TrailBoss	<<locked>>	62%	18260	32%	**7	100%
Maxam CSB 1	<<locked>>	61%	44643	79%	**30	100%
Maxam CSB 3	<<locked>>	61%	46093	81%	**43	100%
Maxam CSB 4	<<locked>>	61%	46862	83%	**40	100%
Maxam CSB 5	<<locked>>	61%	46296	82%	**20	100%
ReloadSwiss RS 14	<<locked>>	60%	17912	32%	**0	100%
ReloadSwiss RS 30	<<locked>>	61%	33112	59%	**02	98%
SNPE Vectan A0	<<locked>>	61%	47094	83%	**83	100%
SNPE Vectan BA10	<<locked>>	61%	43265	76%	**78	100%
SNPE Vectan BA6 1/2	<<locked>>	61%	30269	54%	**20	100%
Somchem S265	<<locked>>	61%	36390	64%	**32	97%
Vihtavuori N110	<<locked>>	61%	37782	67%	**45	100%
Vihtavuori N32C Tin Star	<<locked>>	61%	31270	55%	**07	100%

Start Load - Barrel Length: 5.50''

Any powder missing? Then click here.

FR ... fill rate of the cartridge in percent

MaxP ... max. pressure of load in psi or bar

% ... max. pressure of load in percent of the maximum allowed pressure for this caliber

V(0) ... muzzle velocity in feet per second (fps) or meters per second (m/s)

z ... powder burnt in percent

[...] *... not dangerous but load has suboptimal powder burnt with possible characteristics such as extensive muzzle flash or inaccurate loads.

[...] ²... fill rate low - you might want to consider using a filler to ensure proper ignition.

[...] ᴾ... possible press load - work up slowly to this load while watching for signs of excessive pressure.

👍 ... recommended powder/load for this caliber and bullet combination based on its ballistic performance.

<<locked>>... you need to buy an access license to unlock the data